Technics
Audio & Hifi
Maintenance & Repair
Cables
DJ Gear
Vinyl
0
Your Cart
Nagaoka JN-P200
Hover over an image to enlarge
Nagaoka JN-P200
Original replacement stylus from the Nagaoka MP-200 cartridge.
ALBEPRO is NAGAOKA's official dealer in the Netherlands
The complete "MP" program and the new "JewelTone" series from Nagaoka can be found in our program including the new DJ-44G replacement needle.
Nagaoka program
Specs
| Cartridge and Stylus | |
| Model | MP-200 |
| Type | Moving Permalloy |
| Frequency Response | 20-23.000 Hz |
| Vertical Tracking Angle | 30 ° |
| Vertical Tracking Force | 1.5 – 2.0 g |
| Recommended VTA (VTF) | 1.5 g |
| Stylus Construction | Naked diamond, square shrank |
| Stylus Shape | Elliptical |
| Stylus Curvature Radius | 0,4 x 0,7 mil |
| Recommended Load Impedance | Min. 47K ohms (when head amplifier is connected) |
| Recommended Load Capacitance | 100 pF |
| Coil Impedance | |
| DC Resistance | |
| Coil Inductance | |
| Output Voltage | 4.0 mV (at 1 kHz, 5 cm/sec) |
| Output Channel Balance | Better than 1.5 dB (1 kHz) |
| Channel Separation | Better than 25 dB (1 kHz) |
| Cantilever | Boron, 0.28mm diameter |
| Static Compliance | |
| Dynamic Compliance | 7.2 x 10-6 cm/dyne (100 Hz) |
| Mounting | Half-inch |
| Cartridge Weight | 6.5 g |
| Cartridge & headshell Weight | 16.5 g |
| Wire Used for Coil | High Purity Copper Wire （φ0.04 3UEW） |
| Body Material | Anti-ferro magnetic permalloy shield casing |
| ABS resin | |
| Mounting Feature | Half-inch mount |
| Terminal Pins | Brass（gold plated） |
| Dimensions | 18.0 mm H × 17.0 mm W × 28.6 mm D |
| Accessories Included (cartridge only) | non-magnetic screwdriver |
| 2 washers & 2 nuts | |
| cartridge installation screws | |
| 10 mm × 2,8 mm × 2 | |
| 13 mm x 2,8 mm x 2 | |
| plastic protector; | |
| Accessories Included (cartridge +Headshell) | plastic protector |
| Notes | Mounting Feature: |
| Note: |